Metlink part-train, part-bus replacements: plan the taps at the changeover
- Sources checked
Llandora · Prepared with Codex AI assistance
Editorial record
These dates record the stated work, not professional certification or a continuing fact-check.
Source changes and editorial checks are separate; an absent date means no check is recorded here.
Source text changed since your saved version. This does not establish a new factual review.
On this device
Saving a guide stores its ID and the source version for this language in this browser only. No account is needed. Clear your list at any time; clearing browser data also removes it.
Editorial standards and disclosures
Scope and limitations. Llandora publishes educational guides and illustrative tools. Reading a guide or using a calculator does not create a professional relationship. Examples and estimates omit individual circumstances and may be incomplete or outdated. Check dates, assumptions and the official authority for your jurisdiction. Do not use this site for medical, dental or health advice. No approval, savings, investment return or other outcome is promised. Nothing in this notice excludes consumer rights or liability that applicable law does not allow us to exclude.
On this page
Start here
For a Wellington journey split between a train and a replacement bus, close the train part at the platform reader, then use the reader on the replacement bus for the bus part. Do not treat the changeover as an ordinary uninterrupted train ride. This is the distinction in Metlink’s Snapper instructions.
Match the payment step to the vehicle
Metlink distinguishes a bus replacing a whole train trip from a bus replacing only part. For the whole replacement, use the bus reader rather than the platform. For the split journey, its instructions require both the train-platform taps and the bus taps. It also says a passenger can still travel if tagging on the replacement bus is not possible.
Build a changeover note before leaving
Write the journey as separate lines: train origin to interchange; interchange to destination by replacement bus. Beside each line put the place where you expect to use the reader. Add the replacement stop location from the actual service notice. A journey planner’s destination alone does not tell you where the bus will collect passengers.
An illustrative split journey might have a train arriving at the interchange while the onward bus leaves from outside the station. Finish the train payment step before following signs to the bus. At the bus, look for the onboard reader and follow staff instructions if it cannot be used. This is a planning example, not a claim that any named service is disrupted today.
Before the return, repeat the check in reverse. Keep the service notice and approximate travel times if you later need help understanding the trip record. Do not guess a fare adjustment or promise a free transfer from this explanation; this guide addresses where to tag.
Sources and scope
- Using Snapper — Where to tag on and off, checked 30 October 2026. Scope: How should a Snapper user tag when a replacement bus covers only part of a Wellington rail journey?
- This is a source-led explainer, not a claim that the topic is trending. The practical scenario is illustrative; no personal visit, booking or transaction is claimed. Confirm current arrangements with the named operator before acting.
Disclaimer: General information only, not professional or individualized advice. Check the linked official source and confirm arrangements with the operator before acting. Availability and procedures can change.
Editorial note: Prepared with AI assistance. No paid placement, affiliate link, supplied benefit or third-party media is included.
More practical guides
Browse related destination guides and Llandora's editorial approach.
This checkbox records your choice only on this device; it does not verify completion or notify anyone.
My reading